GRINDER SELECTION TABLE

Select the Correct model as per your requirement.

Model RPM Phase Volts H.P. Cutters Can be Used Operations can be done Area of Application Speedo 80 8000 3 415 1.0 Mounted points, Resin bonded Grinding Wheel up to 4” Plain/DCD Die Grinding, Debarring, with Tungsten Carbide Cutter, Rotary Cutter, Most Suitable for Foundries of Cast Iron and Alloy Steel for fine finishing /Fettling, For Forging Shop Speedo 58 5800 3 415 1.0 Heavy Fettling and cutting, Cutter wheel, Grinding wheel plain/DCD up to 7”, Buffing, Polishing, Sanding Foundries for primary heavy fettling and cutting, Forging and Fabrication shops for weld grinding and Buffing. Speedo 58 5800 3 415 1.5 Speedo 120 12000 3 415 1.0 Mounted points, Die Grinding, Debarring, with Tungsten Carbide Cutter, Rotary Cutter, Foundries for final finish with mounted point, For Pattern Shop Speedo 28 2800 3 415 1.5 For Welding Grinding, Buffing, Polishing, Sanding For Fabrication shop, Rubber Retreading Speedo 58/28 (two speed) 5800 2800 3 415 1.5 For Weld Grinding, Buffing Most Suitable for Fabrication Shop

Selection of Shaft and Tool Holder

Hints for Selection of Shaft

For length: The Shaft length is provided in various sizes to suit individual’s geometry of the product. You have to select the adequate length of the shaft so that you can use grinder comfortably with minimum bends and curves. At the same time avoid excess length of shaft, as more the shaft length more the cost and more the wear. For Type: The metal shaft is lighter in weight and less fatigue to operator.  The Rubber shafts are more durable than metal but heavier in weight.   Model RPM Flexible Shaft Size/Type Can Use Tool Holder can Use Application Speedo 80 8000 10 X1500 MM Metal / Rubber 10 X 2000 MM Metal / Rubber 10 X 1200 MM Metal 12 X 1500 MM Metal FSH 10 with 6/6.35 MM Collate For Mounted Points & Cutters WSH 10 For Grinding Wheels Speedo 120 12000 10 X1500 MM Metal 10 X 1200 MM Metal FSH 10 with 6/6.35 MM Collate For Mounted Points & Cutters Speedo 58 5800 15 X 2000 MM Metal / Rubber 15 X 1500 MM Metal / Rubber 15 X 3000 MM Metal WSH 15 For Grinding Wheels, Buffing Etc. To use mounted point Collate holder with 6/6.35 MM Collate Speedo 28 2800 15 X 2000 MM Metal 15 X 1500 MM Metal Speedo 58/28 (two speed) 5800 2800   Variety of Tool Holders

Copyright © 2006-2007 Kaustubh Engineering Services. All rights are reserved. Best Viewed in IE 5.0+ and 800x600 Resolution